Table of Contents
Advertisement
5-4.
Control Section
5-4-1.
CA-92 Board (XVS-9000/XVS-8000/XVS-7000/XVS-6000), CA-92A Board
(XVS-9000)
The CA-92/CA-92A board performs the following processing.
• Various kinds of control by the CPU-DP module
• Gigabit Ethernet HUB
• Generating a clock signal and a timing signal in synchronization with the reference signal
• Monitoring entire unit
Various kinds of control by the CPU-DP module
Device control on the board
The CPLD (IC1) decodes the bus address of the CPU-DP module and generates chip select signals and buffer control
signals. With these signals, the CPU-DP module reads and writes the flash memory and peripheral devices on the board.
Controlling video signal processing boards through the external bus
The CPLD (IC1) generates buffer control signals from the CPU-DP module bus. With these signals, EXTBUS (for the
FRONT board) and EXTBUS2 (for the REAR board) are extended to control boards connected to EXTBUS and
EXTBUS.
Gigabit Ethernet HUB
A 12-port hub is formed by using the Gigabit Ethernet HUB chip (IC1401, 1501, IC1601) to enable communication
between video signal processing boards connected to the hub.
Generating a clock signal and a timing signal in synchronization with the reference signal
Clock Generation
IC2001 generates HSOUT, VSOUT, and OEOUT signals from the REF_IN signal that is input from the MB board
IC2003 generates VCLK signals for HD and SD by using these signals.
Clock Distribution
VCLK signals generated in IC2003 and the TOF and UID signals from the CPLD (IC2) are output through the differential
*1
buffer to the MB board
. With these signals, necessary clock signals are distributed to video signal processing boards
*1
connected to the MB board
.
Monitoring entire unit
Fan speed control
The speed of the fans (XVS-9000: 9 pcs, XVS-8000: 8 pcs, XVS-7000: 4pcs, XVS-6000: 2 pcs) on the side of the unit
is controlled while monitoring the unit inside temperature.
Monitoring power unit status
The power unit status is monitored by reading four status signals (PS_DC_OK, PS_AC_OK, PS_FAULT, PS_EXIST)
from the power units (XVS-9000: 6 pcs, XVS-8000/XVS-7000: 4 pcs, XVS-6000: 2 pcs) and the detailed status in the
power unit through the PS_I2C bus.
Based on the obtained information, power consumption of video boards in the unit is controlled by the DC_ENABLE
signal.
*1:
XVS-9000 is MB-1249 board, XVS-8000 is MB-1223 board, XVS-7000 is MB-1233 board, XVS-6000 is MB-1234 board.
XVS-9000-C/XVS-8000-C/XVS-7000-C/XVS-6000-C
*1
.
5-6
Hide quick links:
Advertisement
Table of Contents
