Mains Transformers; Interface - Atlas XENOTEST BETA LM Operating Manual

ATLAS
Change of paper roll: (fig.15)
Figure 15
Roll
1. Press locking latch to the right and swing
front panel open.
2. Remove old paper roll.
3. Fit new paper roll in such way that it turns
clockwise when unwinding.
4. Cut edges of the paper and insert paper-
roll (note fig. 15).
5. Keep „LINE FEED/ENTER" key
depressed until the beginning of the paper
appears below the tear-off edge.
6. Close front door (locking latch must
engage), the LED "ALARM" will go out,
and the printer is ready for operation.
5.1.3

Mains transformers

(fig.16)
The mains transformers are needed for specific
mains adaptations in the various countries and are
fitted to the lower, right side of the unit. (see fig.
8.18).
Figure 16
XENOTEST BETA
Safety hints
Program example on
Function
XENOTEST BETA
Paper inlet slot
Unit set-up
Features
Test set-up
Operating manual XENOTEST BETA LM
5.1.4 Interface (fig. 17)
The unit supports an RS 232 or RS 485 interface
alternatively to give out measurement data to a
computer whilst a program is in progress.
With the accessory-package XENOVIEW consi-
sting of:
- connection cable
- software
- operating manual
the interface can be driven.
(seriell 9-pole Id. No. 56076813)
(seriell 25-pole Id.-No. 56076812)
Connect the interface of the unit with the seriell
interface of the computer.
Figure 17: Software Xenoview
Options and accessory
Unit description
of the XENOTEST BETA
Care and cleaning Maintenance
Start-up
List of options
and accessories
Page 27