Atlas XENOTEST BETA LM Operating Manual page 25

ATLAS
The printer parameters (fig. 13) are preset
in the factory, and must not be changed.
Basic parameters of the printer (fig. 13)
The basic parameters were preset in the factory as follows:
Figure 13: Printer parameters
PRINT INTERVAL
PRINTER ADDRESS
DATA FORMAT
BAUDRATE
INTERFACE
CHARACTER SET
CHARACTERS/LINE
PRINT FORMAT
PRINT STRENGTH
MODE
Change of printer parameters: (fig. 14)
1. For access to the menu, press
„MENU/SELECT" key for more than 3 seconds.The
following message will be printed out.
ACTUAL PARAMETER? PRESS „ENTER"
2. Press „LINE FEED/ENTER" key. The printer
prints out current parameters and shows the
following message.
CHANGE OF PARAMETERS?
XENOTEST BETA
Safety hints
Program example on
Function
XENOTEST BETA
Unit set-up
Features
Test set-up
Operating manual XENOTEST BETA LM
Paper tear-off bar :
To tear off the paper strap, tear paper quickly
upwards from one side to the other.
NO
00-PRINT ALWAYS
8 NO PARITY
2400
SERIAL
NATIONAL LANGUAGE
40
INVERSE
.....+.....
ON LINE
3. To change the printer parameters, press
„LINE FEED/ENTER" and „MENU/SELECT" for
more than 4 seconds. Afterwards the single
parameters are listed and can be confirmed by
pressing „LINE FEED/ENTER" or be changed by
pressing „MENU/SELECT".
4. To exit the menu programm, press „MENU/
SELECT" and „LINE FEED/ENTER" keys
simultaneously, or the program is automatically
terminated after 3 minutes without actuating any
key.
Options and accessory
Unit description
of the XENOTEST BETA
Care and cleaning Maintenance
Start-up
List of options
and accessories
Page 25