Frequently Asked Questions - Bosch D9412GV3 Quick Reference Manual

24 en | Frequently Asked Questions
11

Frequently Asked Questions

What does it mean when my keypad reads "CALL FOR SERVICE"?
That keypad is not receiving data from the control panel.
What does it mean when my keypad reads "SERVICE KEYPAD"?
A supervised keypad has lost communications with the control panel.
How do I arm an area that is not assigned to my keypad?
Add to the FUNCTION LIST a menu item with a function code of 1 and with CC ADDRESS 1-16
set to YES, and a menu item with a function code of 2 and with CC ADDRESS 1-16 set to Yes.
Assign the function codes to the necessary command center. The new menu items allow your
users to select the area they wish to arm or disarm.
How do I perform area-specific functions from a keypad?
Use the MOVE TO AREA command (CMD 50) to move to an area within the keypad's scope.
Can I default a lockcode without knowing the lockcode?
No. You must send the unit to the Bosch Repair Center.
How do I upgrade the control panel version?
Use the supplied firmware upgrade key to upgrade the firmware. Lift the control panel
faceplate cover to access the port to insert the upgrade key and read the instructions located
on the back of the faceplate.
How do I add an access card using the command center?
Use the ADD USER command (CMD 56) to add an access card. Present the access card to the
assigned door to add the card.
What does it mean when my keypad reads "9210 NOT READY"?
No door is assigned to the command center. Check the ASSIGN DOOR parameter within
COMMAND CENTER ASSIGNMENTS menu item, and then enter the D9210B address (1 - 8).
What are SDI addresses 33 to 40?
They are D9210B addresses.
What are SKEDS 41 to 56?
They are Open and Close windows.
How do I test a relay from the keypad?
Use the RELAY CONTROL command (CMD 54) to toggle relays.
How do I toggle the on-board relays A, B, and C?
Use the RELAY CONTROL command (CMD 54), and then the relay number: 253 for A; 254 for
B; and 255 for C.
How many Amp Hours can the panel sustain?
You can connect two (2) 18 Ah batteries for a total of 36 Ah. You can gain up to an additional
27 Ah with by connecting a D8132 module.
Is the control panel compatible with digital or VOIP phone lines?
The control panel has been tested with only analogue lines. Use a DX4020 to transmit over
Ethernet or a ITS-DX4020-G to transmit over cellular. You can use a C900V2 to convert
analogue signals to Ethernet for transmission to a D6600 receiver.
How do I silence a trouble condition?
Use the SILENCE TROUBLE SOUNDER command (CMD 4) to silence a trouble condition.
F01U170805 | 01 | 2010.11 Quick Reference Guide
D9412GV3/D7412GV3/D7212GV3
Bosch Security Systems, Inc.