Frequently Asked Questions (Faq); Programming Questions - Bosch ICP-EZM2 Installer's Manual

Easy Series (ICP-EZM2) | Installer Guide | 7.0 Reference Materials
7.6

Frequently Asked Questions (FAQ)

7.6.1

Programming Questions

Can I program the control panel if I do not have a phone line connected to it?
Yes. Follow these steps:
1. Connect a phone set to the phone set posts on the control panel board.
2. Press and hold the system test button for approximately 15 sec.
3. Enter the installer passcode when prompted.
The emergency buttons on the control center do not work. How do I activate them?
By default, the emergency buttons are turned off. Follow these steps to turn them on:
1. Start a phone session. Refer to Section 1.3 Basic Operation Information on page 4 for instructions.
2. Enter the installer passcode.
3. Press [4] to select Expert Programming.
4. Enter the following expert programming item numbers, and change the setting for each button:
•
888 = fire alarm (0 = disabled, 1 = fire alarm)
•
889 = medical alarm (0 = disabled, 1 = medical alarm)
•
890 = panic alarm (0 = disabled, 1 = audible panic alarm, 2 = silent panic alarm)
5. Ensure that the following reports are enabled:
•
319 = user emergency (1 = Route 1 only, 2 = Route 2 only, 3 = both routes)
•
320 = user fire (1 = Route 1 only, 2 = Route 2 only, 3 = both routes)
•
322 = user panic (1 = Route 1 only, 2 = Route 2 only, 3 = both routes)
6. Press [#] repeatedly until you hear the system say "goodbye." The buttons are now active.
How do I program a duress passcode?
Follow these steps:
1. Start a phone session. Refer to Section 1.3 Basic Operation Information on page 4 for instructions.
2. Enter the installer passcode.
3. Press [4] to select Expert Programming.
4. Press [8][6][2] to select Expert Programming Item Number 862, and then press [1] to enable the duress user (User
22).
By default, the duress passcode is "1111" if the passcode length = 4 digits, or "111111" if the passcode length = 6
digits.
5. Press [#] until you hear the system say "goodbye."
6. Start a new phone session.
7. Enter the master user passcode.
8. Press [4] to select the User Menu.
9. Press [2] to change a user.
10. Press [2] repeatedly to scroll through all available users until you reach User 22.
11. Press [1] to select User 22.
12. Press [3] to enter a new passcode.
13. Enter a new passcode. Only digits 1 through 5 are allowed.
You cannot assign a token to User 22.
14. Press [1] to return to User Menu selections.
15. Press [#] repeatedly until you hear the system say "goodbye."
The duress user (User 22) is now active.
64 Bosch Security Systems, Inc. | 5/07 | F01U025147-01