TabletKiosk Sahara Slate PC i500 User Manual page 118

4. If you are adding only
one module and there
is an empty slot avail-
able, proceed to step 6.
Otherwise, using your
fingers or a small screw-
driver, pull the two metal
restraining clips on both
sides of the RAM module
outward and away from
the module. The top
edge of the RAM module
should pop up slightly
when freed from the
restraining clips.
5. Gently pull out the RAM
module. Try not to touch
the module's connector
pins to keep them clean
in case you'd like to use
this module again.
6. To insert a new RAM
module, align the
connector pins on the
bottom of the RAM
module with the RAM slot
and slide the module into
the slot at the same angle
as when you removed it.
7. Once properly inserted
in the slot, press the RAM
module down flat until
it clicks into place. Make
sure that you have seated
the module completely
into the slot before press-
ing it down. A properly
116 Chapter 06: Upgrading Your Sahara Slate PC