Settings - Siemens SIPROTEC 4 Manual

Address 664 IP adr[0] (Sec) to 667 IP adr[3]
(Sec)
Address 668 Client activ
Address 669 Daylight Set
Address 670 Offset TZ/min
Address 671 Offset DayT/min
Address 672 W2S month to 675 W2S hour
Address 676 S2W month to 679 S2W hour
Access authorization for port A
At address 651 ParEN100(LC)blk you can parameterize a read access option via the EN100 module at port
A. If the parameter is set to ON, you can read out the device parameters using DIGSI or fetch fault records.
IEC 61850 GOOSE Function
At address 700 GOOSE-Stop you can set the GOOSE function of the IEC 61850 protocol to active or not. If
GOOSE-Stop is set to YES, you can release the GOOSE function again via a binary input during operation.

Settings

2.1.2.3
Addr. Parameter
610 FltDisp.LED/LCD
611 Spont. FltDisp.
640 Start image DD
651 ParEN100(LC)blk
660 IP adr[0](Prim)
661 IP adr[1](Prim)
662 IP adr[2](Prim)
663 IP adr[3](Prim)
664 IP adr[0] (Sec)
665 IP adr[1] (Sec)
666 IP adr[2] (Sec)
667 IP adr[3] (Sec)
668 Client activ
669 Daylight Set
670 Offset TZ/min
671 Offset DayT/min
SIPROTEC 4, 7SJ80, Manual
E50417-G1140-C343-A8, Edition 12.2017
Setting Options
Target on PU
Target on TRIP
YES
NO
image 1
image 2
image 3
image 4
image 5
image 6
OFF
ON
0 .. 255
0 .. 255
0 .. 255
0 .. 255
0 .. 255
0 .. 255
0 .. 255
0 .. 255
OFF
ON
OFF
ON
-1440 .. 1440 min
-1440 .. 1440 min
IP-Addresses 0 to 3, NTP secondary
client for primary and secondary addresses switched
on or off.
daylight saving time switched on or off.
offset for the time zone in minutes
offset for daylight saving time in minutes
month, week (of the month), day of the week, hour
of switching to daylight saving time
month, week (of the month), day of the week, hour
of switching to winter time
Default Setting Comments
Target on PU Fault Display on LED / LCD
NO Spontaneous display of flt.annun-
ciations
image 1 Start image Default Display
OFF DIGSI-config. over EN100 (LC)
blocked
0 IP address [0] (NTP-Primary)
0 IP address [1] (NTP-Primary)
0 IP address [2] (NTP-Primary)
0 IP address [3] (NTP-Primary)
0 IP address [0] (NTP-Sekundary)
0 IP address [1] (NTP-Sekundary)
0 IP address [2] (NTP-Sekundary)
0 IP address [3] (NTP-Sekundary)
OFF Client activ
OFF Daylight Set
60 min Offset for time zone in minutes
60 min Offset for daylight in minutes
Functions
2.1 General
35