System Defaults
The switch's system defaults are provided in the configuration file
"Factory_Default_Config.cfg." To reset the switch defaults, this file
should be set as the startup configuration file. See "Setting the Startup
Configuration File" on page 2-19.
The following table lists some of the basic system defaults.
Function
IP Settings
Web Management HTTP Server
SNMP
Security
Parameter
Management. VLAN
DHCP
BOOTP
User Specified
IP Address
Subnet Mask
Default Gateway
HTTP Port Number
Community Strings
Authentication Failure
Traps
Link-up-Down Traps
Privileged Exec Level
Normal Exec Level
Enable Privileged Exec
from Normal Exec Level
RADIUS Authentication Disabled
S
YSTEM
Default
1
Enabled
Disabled
Disabled
0.0.0.0
255.0.0.0
0.0.0.0
Enabled
80
"public" (read only)
"private" (read/write)
Enabled
Enabled
Username "admin"
Password "admin"
Username "guest"
Password "guest"
Password "super"
D
EFAULTS
1-13