Command Groups - SMC Networks SMC6750L2 Management Manual

C L
OMMAND INE

Command Groups

The system commands can be broken down into the functional groups
shown below
Command
Group
General
Flash/File
System
Management
Radius Client
SNMP
IP
Line
Interface
Address Table
Spanning Tree
VLAN
GVRP and
Bridge Extension
IGMP Snooping
3-10
I
NTERFACE
.
Description
Basic commands for entering privileged access mode,
restarting the system, or quitting the CLI
Manages code image or switch configuration files
Controls system logs, system passwords, user name,
browser management options, and a variety of other
system information
Configures RADIUS client-server authentication for
logon access
Activates authentication failure traps; configures
community access strings, and trap managers
Configures the IP address and gateway for
management access, displays the default gateway, or
pings a specified device
Sets communication parameters for the serial port,
including baud rate and console time-out.
Configures the connection parameters for all
Ethernet ports, aggregated links, and VLANs
Configures the address table for filtering specified
addresses, displaying current entries, clearing the
table, or setting the aging time
Configures Spanning Tree settings for the switch
Configures VLAN settings, and defines port
membership for VLAN groups
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for bridge
extension MIB
Configures IGMP multicast filtering, querier
eligibility, query parameters, and specifies ports
attached to a multicast router
Page
3-12
3-18
3-24
3-38
3-43
3-49
3-56
3-67
3-78
3-83
3-93
3-104
3-109