Bridge Priority - SMC Networks SMC6750L2 Management Manual

• The minimum value is the higher of 6 or [2 x (hello-time + 1)].
• The maximum value is the lower of 40 or [2 x (forward-time - 1)].
Default Setting
20 seconds
Command Mode
Global Configuration
Command Usage
This command sets the maximum time (in seconds) a device can wait
without receiving a configuration message before attempting to
reconfigure. All device ports (except for designated ports) should
receive configuration messages at regular intervals. Any port that ages
out STA information (provided in the last configuration message)
becomes the designated port for the attached LAN. If it is a root port,
a new root port is selected from among the device ports attached to the
network.
Example
Console(config)#bridge 1 max-age 40
Console(config)#

bridge priority

Use this command to configure the spanning tree priority globally for this
switch. Use the no form to restore the default.
Syntax
bridge bridge-group priority priority
no bridge bridge-group priority
• bridge-group - Bridge group index (bridge 1).
• priority - Priority of the bridge. (Range: 0 - 65535)
Default Setting
32768
S T
PANNING REE
C
OMMANDS
3-87