Measurement Results Seem Unrealistic - Kompernass KH 5518 Operating Instructions Manual

Subsequently carry out the measurement
again.
11.4.3. "––––"
Th is error message indicates that the display re-
mote control unit can not establish a connection
to the scales. Possible causes for this could be:
A
Th e scales are turned off . Turn the scales
on by gently touching the top of the sca-
les with your foot.
B
Th e display remote control unit is too far
away from the scales. In this case, move
closer to the scales with the display remo-
te control unit.
C
Th ere is an obstacle between the infrared
receiver on the display remote control
unit and the scales. In this case, remove
the obstacle.
D
Th e display remote control unit is being
held at an angle which hinders connec-
tion between the infrared receiver and
the scales. In this case, hold the display
remote control unit with the infrared re-
ceiver facing the scales.
11.5. Measurement results
seem unrealistic
If you doubt the correctness of the displayed
measurement results:
A
Make sure you are carrying out the mea-
surements correctly:
Ú
Are you carrying out the measurement
without clothes on and especially without
shoes and socks on?
Ú
Do you have both feet on the scales
sensor areas whilst weighing?
Ú
Are your feet dry and clean?
Ú
Do you remain still on the scales until the
measurement results are displayed?
If you have carried out the measure-
ments correctly:
B
Make sure that the stored personal data is
correct. If errors were made when making
the entries, it could result in false results.
To do this:
1
Turn the display remote control unit on
by pressing the on/off button.
2
Subsequently press the up or down but-
ton once briefl y. 1-10 appears on the dis-
play screen. Subsequently the number of
one of the memory locations for personal
data will blink on the screen.
3
Select the memory location of your own
personal data by pressing the up or down
button. Press the i button when the memo-
ry location number corresponding to your
personal data is displayed on the screen.
4
Make sure that the displayed data cor-
rectly corresponds to your personal data.
If the displayed data contains errors, then
you have to store your personal data again.
Th e process of storing personal data is ex-
plained in chapter 8. "Prior to initial use".
If the entered personal data contains
no errors:
C
Carry out measurements daily over a pe-
riod of one week. If these measurement
return similar results: Compare your
measurement results with the average va-
lues in the tables in the accompanying
informational material. Use the average
values to determine whether there are lar-
ge diff erences between these values and
your own measurement results. If this is
english 15