The Display Remote Control Unit Can Not Be Turned On; The Display Screen Is Not Functioning Properly; Error Messages Appear On The Display Screen; 0-Ld - Kompernass KH 5518 Operating Instructions Manual

Body composition scale
Hide thumbs Also See for KH 5518:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
11.2. The display remote control
unit can not be turned on
If you can not turn on the display remote con-
trol unit by press the on/off button:
A
Check to make sure that the batteries have
been properly inserted in the compart-
ment on the back of the display remote
control unit. Make sure that the batteries
are facing the right direction with regards
to polarity (+/–) in the battery compart-
ment. Th e right polarity is depicted on the
inside of the battery compartment.
B
Check to see if the batteries in the display
remote control unit are empty. A warning
symbol will appear on the display screen
before the batteries are completely em-
pty. Th is is also explained in chapter 10.
"Maintenance of the scales". Replace the
batteries with two new AAA/Micro type
batteries.
11.3. The display screen is
not functioning properly
Th e scales contain sensitive electronic com-
ponents. Th erefore it is possible that the sca-
les will not function properly if there are radio
transmission devices in the immediate vicini-
ty. Th is could include mobile phones, walkie-
talkies, CB devices, radio remote control units,
other remote control units and microwave de-
vices. If the display screen is not functioning
properly, you should remove this type of de-
vice from the immediate vicinity of the scales.
In most cases it should suffi ce to switch off the
devices while the scales are being used. In cases
of interference proceed as detailed in Section C
of the following chapter.
ô
Note:
Avoid static charge or discharge because this
could result in display errors or sudden swit-
ching off of the scales.
14
english
11.4. Error messages appear
on the display screen

11.4.1. "0-Ld"

If this error message is displayed, then the
weight on the scales exceeds 180 kg. Th e scales
are not intended for weight exceeding 180 kg.
|
Warning!
Do not place a load of more than 180 kilo-
grams on the scales! Otherwise the scales
could be damaged beyond repair!

11.4.2. "Err"

If this error message is displayed, then the
scales can not measure body fat, muscle mass
and body water percentages.
A
Measurement will not function properly
if you are wearing shoes or socks. Always
take your shoes and socks off before stan-
ding on the scales.
B
Make sure that you have both feet on the
sensor areas of the scales top surface.
If measurement is still not possible:
C
Step off the scales and wait until it auto-
matically shuts off . Subsequently turn the
scales on again and start the measure-
ment process again.
If measurement is still not possible:
D
You should always carry out measurements
with clean dry feet. In some rare cases ho-
wever your feet could be too dry for the
measurement functions to function pro-
perly. In order to exclude the possibility
that this is the cause of the error message:
Moisten your feet using a damp cloth.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kh 5519

Table of Contents