Measurement Results Seem Unrealistic - Kompernass KH 5518 Instructions For Use Manual

11.4.3. "––––"
Th is error message indicates that the display re-
mote control unit can not establish a connection
to the scales. Possible causes for this could be:
A
Th e scales are turned off . Turn the scales
on by gently touching the top of the scales
with your foot.
B
Th e display remote control unit is too far
away from the scales. In this case, move
closer to the scales with the display re-
mote control unit.
C
Th ere is an obstacle between the infrared
receiver on the display remote control
unit and the scales. In this case, remove
the obstacle.
D
Th e display remote control unit is being
held at an angle which hinders connec-
tion between the infrared receiver and
the scales. In this case, hold the display
remote control unit with the infrared re-
ceiver facing the scales.
11.5. Measurement results
seem unrealistic
If you doubt the correctness of the displayed
measurement results:
A
Make sure you are carrying out the meas-
urements correctly:
Ú
Are you carrying out the measurement
without clothes on and especially without
shoes and socks on?
Ú
Do you have both feet on the scales
sensor areas whilst weighing?
Ú
Are your feet dry and clean?
Ú
Do you remain still on the scales until the
measurement results are displayed?
If you have carried out the measure-
ments correctly:
B
Make sure that the stored personal data is
correct. If errors were made when making
the entries, it could result in false results.
To do this:
1
Turn the display remote control unit on
by pressing the on/off button.
2
Subsequently press the up or down but-
ton once briefl y. - appears on the dis-
play screen. Subsequently the number of
one of the memory locations for personal
data will blink on the screen.
3
Select the memory location of your own
personal data by pressing the up or down
button. Press the i button when the memo-
ry location number corresponding to your
personal data is displayed on the screen.
4
Make sure that the displayed data cor-
rectly corresponds to your personal data.
If the displayed data contains errors, then
you have to store your personal data again.
Th e process of storing personal data is ex-
plained in chapter . "Prior to initial use".
If the entered personal data contains no
errors:
C
Carry out measurements daily over a pe-
riod of one week. If these measurement
return similar results: Compare your
measurement results with the average val-
ues in the tables in the accompanying in-
formational material. Use the average val-
ues to determine whether there are large
diff erences between these values and
your own measurement results. If this is
the case, please consult your physician to
have the measurement results checked.
17