Using The Guest Mode (Gues) - Kompernass KH 5518 Operating Instructions Manual

3
Select the memory location of your own
personal data by pressing the up or down
button. Press the i button when the memo-
ry location number corresponding to your
personal data is displayed on the screen.
4
Your personal data will appear on the dis-
play screen. Aft er a few seconds ...
Ú
Th e body weight appears in the lower
part of the display screen.
Ú
and the percentage of body weight repre-
sented by body fat appears in the upper
part of the display screen.
5
Press the up or down buttons to switch to
the display of measurement results for ...
Ú
the percentage of your body weight which
is body water
Ú
the percentage of your body weight which
is muscle mass
Ú
your daily caloric requirement in kiloca-
lories (kcal)
Your body weight will continue to be dis-
played in the lower section of the display
screen.
Your general health condition is depicted
by a symbol in the lower left corner of the
display screen.
ô
Note:
Details pertaining to the display element are
found in chapter 9.2. "Measuring body weight,
body fat, muscle mass and body water percen-
tages as well as caloric requirement".
12 english

9.5. Using the guest mode (GUES)

If ...
Ú
all ten memory locations for personal
data are already full
Ú
or if you want to measure body weight,
body fat percentage, muscle mass percen-
tage and body water percentage as well as
caloric requirement without storing perso-
nal data.
To do this:
1
Press the on/off button to turn on the dis-
play remote control unit. "Balance" and
"––––" will appear on the display screen.
2
Press the up button once. 1-10 appears
on the display screen. Subsequently the
number of one of the memory locations
for personal data will blink on the screen.
3
Press the up or down button several times
until "GUES" appears on the display
screen. Subsequently press the i button.
Either lb or kg should now be blinking in
the display.
4
Carry out steps 5 to 9 from chapter 8.
"Prior to initial use".
5
Lightly touch the top of the scales with
your foot. Th e on/off indicator on the
scales should be illuminated in red. Af-
ter a few seconds the on/off indicator will
turn green and 0.0 kg will appear in the
display screen.
†
Danger!
Never stand on only one side of the scales. Always
stand in the middle of the scales with both feet.
Th en you stand on the right and left sensor areas.
Otherwise the scales can tilt to the side and be
damaged beyond repair. You could also fall!