Selecting The Paper Tray For Copying - Sharp MX-M6570 User Manual

COPIER►BEFORE USING THE MACHINE AS A COPIER

SELECTING THE PAPER TRAY FOR COPYING

The machine is set to automatically select a tray that has the same size of paper as the size of the placed original (Auto
Paper Select).
If the original size cannot be detected correctly because it is a non-standard size or when you want to change the paper
size for copying, you can select the paper tray manually.
• If the selected tray runs out of paper during a copy job and there is another tray that has the same size and type of paper,
that tray will be automatically selected and the copy job will continue.
• If a suitable size of copy paper is not loaded, copying may stop during the
• To change the initially selected tray:
In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Initial Status Settings] → [Paper Tray].
• Stop auto paper selection
In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Common Settings] → [Disabling of Auto
Paper Selection]
The same size of paper will not be automatically selected when an original is placed on the document glass or the
document tray of the Single Pass Feeder.
• Automatically select the tray used for paper feeding
In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Common Settings] → [Auto Selection Setting
of Tray that is Supplied the Paper]
When this setting is enabled and paper is loaded into a tray while the machine is on standby in copy mode, that tray is
automatically selected.
Tap the [Paper Select] key.
1
► COPYING SEQUENCE (page 2-5)
Tap the required tray key.
2
After the settings are completed, tap
In Easy mode
Paper Select
1
2
3
4
CA
Preview
• When the bypass tray is selected, specify the paper type and size based on the paper loaded into the bypass tray.
► SPECIFYING A TYPE AND SIZE OF PAPER LOADED ON BYPASS TRAY (page 2-34)
• In normal mode, you can also open the [Paper Select] screen by tapping the machine image on the base screen.
To automatically select the tray, tap the [CA] key. When the [CA] key is tapped, all settings selected to that point are
cleared and you will return to the base screen.
.
8½x11
8½x11
Plain
Type and Size
8½x11R
8½x14
11x17
1
Copies Start
COPYING SEQUENCE (page
In Normal mode
Paper Select
Paper Tray
8½x11 8½x11
1 2
Plain 1 Plain 1
8½x14
3
Plain 1
11x17
4
Plain 1
Others
2-11
2-5).
Change Current Type and
1
No. of copies
Size of Selected Tray
Original
Change Size/Direction.
Large Capacity Tray
Copy Ratio
8½x11
Enlarge/Reduce Copy
Plain 1
2-Sided Copy
Margin Shift
Shift Position to Have Margin
Bypass Tray
Preview
8½x11
Plain 1
Proof Copy
Type and Size
3 8½x14
4 8½x11
11x17
CA
Start