Default Settings For Copying - Sharp MX-M6570 User Manual

COPIER►BEFORE USING THE MACHINE AS A COPIER
Tap the [Start] key to start copying.
6
When making only one set of copies, you do not need to specify the number of copies.
• To cancel all settings, tap the [CA] key.
When the [CA] key is tapped, all settings selected to that point are cleared and you will return to the base screen.
• To cancel copying, tap the [Cancel Copy] key.
• To make two or more sets of copies:
Tap the copies display key to specify the number of copies.
In Easy mode
Original
8½x11
Paper
Select
8½x11
Tray 1
CA
Preview
• In normal mode, you can tap [File] or [Quick File] on the action panel before starting the copy job to save the scanned
original as a file.
► QUICK FILE (page 6-9)
► FILE (page 6-10)
Setting a Maximum Number of Copies
In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Condition Settings] → [Setting a Maximum
Number of Copies].
This is used to set the maximum number that can be entered for the number of copies (number of continuous copies).
Any number from 1 to 9999 can be specified.

Default settings for copying

Set in Default Settings of
" "
Initial Status Settings selected with these settings apply to all functions of the machine (not just the copy function).
The copier settings are reset to the initial state when the [Power] button is turned on, when the [CA] key is tapped, or
when the auto clear interval has elapsed. These settings are used to change the default settings for copy mode.
The following settings can be changed:
Item
Image Orientation
Paper Tray
Exposure Type
Copy Ratio
2-Sided Copy
Original Binding
2-Sided Copy Copy Ratio Staple / Punch
100% Off
1 → 1
Copies
Start
Copy Settings in the System Settings. You can set a default value for each copy setting.
" "
Specify the original orientation.
Specify the paper tray that is selected by default.
Configure default exposure mode settings.
Specify the copy ratio that is selected by default.
Configure the 2-sided mode settings that are selected by default.
If this setting is used to change the default setting for the duplex function to any setting
other than "1-Side to 1-Side" and the duplex function or automatic document feeder fails or
is disabled, the setting will revert to "1-Side to 1-Side".
Set the original binding in 2-Sided copy.
In Normal mode
Copies
1
Detail
Original
Auto 8½x11
Paper Select
Auto
2-Sided Copy
1-Sided→1-Sided
Copy Ratio
100%
Exposure
Auto
Output
N-Up
Off
Others
Description
2-7
Send and Print
Quick File
Store Data Temporarily
File
Store Data in Folder
Scan Original Again
Without change Settings
CA
Proof Copy
Start