SMC Networks EliteConnect SMC2555W-AG User Manual page 91

Firmware Upgrade Remote – Downloads an operation code
image file from a specified remote FTP or TFTP server. After
filling in the following fields, click Start Upgrade to proceed.
• New firmware file: Specifies the name of the code file on the
server. The new firmware file name should not contain slashes
(\ or /), the leading letter of the file name should not be a period
(.), and the maximum length for file names on the FTP/TFTP
server is 255 characters or 32 characters for files on the
access point. (Valid characters: A-Z, a-z, 0-9, ".", "-", "_")
• IP Address: IP address or host name of FTP or TFTP server.
• Username: The user ID used for login on an FTP server.
Password: The password used for login on an FTP server.
•
Restore Factory Settings – Click the Restore button to reset the
configuration settings for the SMC2555W-AG to the factory
defaults and reboot the system. Note that all user configured
information will be lost. You will have to re-enter the default user
name (admin) to re-gain management access to this device.
Reset Access Point – Click the Reset button to reboot the system.
Note: If you have upgraded system software, then you must reboot the
SMC2555W-AG to implement the new operation code. Also, to
avoid any configuration settings that may be incompatible with the
new software, reset the access point to factory defaults and clear
the web browser cache.
Advanced Configuration
5-33