SMC Networks EliteConnect SMC2555W-AG User Manual page 76

System Configuration
remove an entry from the table, use the address filter delete
command. To display the current settings, use the show
authentication command from the Exec mode.
SMC-AP(config)#mac-authentication server local
SMC-AP(config)#address filter default denied
SMC-AP(config)#address filter entry 00-70-50-cc-99-1a denied
SMC-AP(config)#address filter entry 00-70-50-cc-99-1b allowed
SMC-AP(config)#address filter entry 00-70-50-cc-99-1c allowed
SMC-AP(config)#address filter delete 00-70-50-cc-99-1c
SMC-AP(config)#exit
SMC-AP#show authentication
Authentication Information
=========================================================
MAC Authentication Server
MAC Auth Session Timeout Value : 300 secs
802.1x
Broadcast Key Refresh Rate
Session Key Refresh Rate
802.1x Session Timeout Value
Address Filtering
System Default : DENY addresses not found in filter table.
Filter Table
MAC Address
-----------------
00-70-50-cc-99-1a
00-70-50-cc-99-1b
=========================================================
SMC-AP#
CLI Commands for RADIUS MAC Authentication – Use the
mac-authentication server command from the global
configuration mode to enable remote MAC authentication. Set the
timeout value for re-authentication using the mac-authentication
session-timeout command. Be sure to also configure
5-18
: LOCAL
: DISABLED
: 5 min
: 5 min
: 300 secs
: DENIED
Status
----------
DENIED
ALLOWED
6-57
6-54
6-55
6-56
6-59