SMC Networks EliteConnect SMC2555W-AG User Manual page 50

Initial Configuration
To connect to the console port, complete the following steps:
1. Connect the console cable to the serial port on a terminal, or
a PC running terminal emulation software, and tighten the
captive retaining screws on the DB-9 connector.
2. Connect the other end of the cable to the RS-232 serial port
on the access point.
3. Make sure the terminal emulation software is set as follows:
• Select the appropriate serial port (COM port 1 or 2).
• Set the data rate to 9600 baud.
• Set the data format to 8 data bits, 1 stop bit, and no parity.
• Set flow control to none.
• Set the emulation mode to VT100.
• When using HyperTerminal, select Terminal keys, not
Windows keys.
Note:
4. Once you have set up the terminal correctly, press the [Enter]
key to initiate the console connection. The console login
screen will be displayed.
For a description of how to use the CLI, see "Using the Command
Line Interface" on page 6-1. For a list of all the CLI commands
and detailed information on using the CLI, refer to "Command
Groups" on page 6-10.
4-2
When using HyperTerminal with Microsoft
sure that you have Windows 2000 Service Pack 2 or later installed.
Windows 2000 Service Pack 2 fixes the problem of arrow keys not
functioning in HyperTerminal's VT100 emulation. See
www.microsoft.com for information on Windows 2000 service packs.
® ®
Windows 2000, make