SMC Networks EliteConnect SMC2555W-AG User Manual page 82

System Configuration
CLI Commands for VLAN Support – From the global
configuration mode use the native-vlanid command to set the
default VLAN ID for the Ethernet interface, then enable VLANs
using the vlan enable command. When you change the access
point's VLAN support setting, you must reboot the access point to
implement the change. To view the current VLAN settings, use
the show system command.
SMC-AP(config)#native-vlanid 3
SMC-AP(config)#vlan enable
Reboot system now? <y/n>: y
SMC-AP#show system
System Information
===================================================
Serial Number
System Up time
seconds
System Name
System Location
System Contact
System Country Code : US - UNITED STATES
MAC Address
IP Address
Subnet Mask
Default Gateway
VLAN State
Native VLAN ID
IAPP State
DHCP Client
HTTP Server
HTTP Server Port
Slot Status
Software Version
===================================================
SMC-AP#
5-24
: A324003220
: 0 days, 0 hours, 32 minutes, 51
: r&d
:
: Contact
: 00-30-F1-91-91-5B
: 192.168.2.51
: 255.255.255.0
: 192.168.2.250
: DISABLED
: 3
: ENABLED
: ENABLED
: ENABLED
: 80
: Dual band(a/g)
: v3.0.02
6-101
6-100
6-33