SMC Networks EliteConnect SMC2555W-AG User Manual page 86

System Configuration
CLI Commands for SNMP – Use the snmp-server enable
server command from the global configuration mode. To set
read/write and read-only community names, use the
snmp-server community command. Use the snmp-server
location and snmp-server contact commands to indicate the
physical location of the access point and define a system contact.
The snmp-server host command defines a trap receiver host. To
view the current SNMP settings, use the show snmp command.
SMC-AP(config)#snmp-server enable server
SMC-AP(config)#snmp-server community alpha rw
SMC-AP(config)#snmp-server community beta ro
SMC-AP(config)#snmp-server location WC-19
SMC-AP(config)#snmp-server contact Paul
SMC-AP(config)#snmp-server host 10.1.19.23 alpha
SMC-AP(config)#exit
SMC-AP#show snmp
SNMP Information
============================================
Service State
Community (ro) : ****
Community (rw) : *****
Location
Contact
Traps
Host Name/IP
Trap Community : *****
=============================================
SMC-AP#
5-28
: Enable
: WC-19
: Paul
: Enabled
: 10.1.19.23
6-37
6-35
6-39
6-36
6-38
6-40