Performing A System-Assisted Shutdown (Shutdown Set) - Siemens ADVIA 2400 Operator's Manual

Performing a system-assisted shutdown (Shutdown set)

1. Verify that sufficient system reagents and wash solutions are available for the startup
you want to run.
2. At the Menu Panel, select
3. In the Mode set list, select
4. Verify the selections for the shutdown you want to run.
If no shutdown is defined or you want to change an existing one, proceed as follows:
a. For each of the Proc. set, Set1, Set2, or Set3, you can select one of the following:
b. Select
c. To confirm, select
5. In the Select wash routine area, select
6. In the Proc.set list, select the shutdown setting (Set1, Set2, or Set3) you want to run.
7. Verify that the system is in Ready mode.
8. In the Start selected routine area, select
The current operating mode displays in the System mode box, and the time remaining
to complete the shutdown displays in the Time until end box.
9. To halt the shutdown, do the following:
a. At the System Startup/Shutdown Settings window, select
b. In the Start instructions area, select
c. At the Operation Panel, select
NOTE:
Exit command from the System(S) menu on the Menu Panel.
90
Maint.
Shutdown set
(1) In the System p.s. area, if you want the system to turn off analyzer power
after the shutdown is completed, check the box next to Power OFF.
(2) In the System end area, select the software shutdown mode you want.
(3) In the PRIME area, select the prime you want to run or select
A Prime is required only if a system reagent is replenished or a related
component is replaced.
(4) Select the check box next to each wash you want to perform.
Select for the shutdown wash.
WASH2
.
Save
.
Yes
To avoid entering the Wait state and not shutting down properly,
, then select
System Startup/Shutdown Settings
.
.
Shutdown
.
Yes
.
Cancel
.
Stop
ADVIA 2400 Operator's Guide
.
.
NONE
.
Stop
do not use the