Parameters Accessed Via Drop-Down Menus - Siemens SITRANS F Operating Instructions Manual

C.1.12

Parameters accessed via drop-down menus

Click on Device, View or Diagnostics to open the associated drop-down menus.
Drop-down menus
Table C-1
Device menus
Communication Path
Communication (Modbus)
Download to Device
Upload to PC/PG
Update Diagnostic Status
Set Address
Wizard - Quick Start
Wizard - Clamp-On Configuration...
Wizard - Inline Configuration...
Trim Signal Output (online dialog)
Totalizer (online dialog)
Multipoint calibration
FW update
Maintenance (online dialog)
Suppress Alarms
Audit Trail
Simulation (online dialog)
Access Management
Reset (online dialog)
FST020 IP65 NEMA 4X
Operating Instructions, 09/2017, A5E41425845-AB
Device menus
C.1 Commissioning with PDM
Description
Shows the communication interface (HART modem)
Shows the communication interface (Modbus interface)
Downloads all writable parameters to the device
Uploads all parameters from the device to the parameter
table
Reads current diagnostic status from the device and up‐
dates the diagnostic status icon
Sets the HART polling address
Guide for a quick commissioning
Guide for a configuration of clamp-on sensors
Guide for a configuration of inline sensors
Calibration of current output (channels 2 to 4)
Controlling totalizers 1, 2 and 3
The multipoint calibration allows the user to set a calibra‐
tion curve, if deemed necessary, at various flow rates
across the range of operation
A FW update is a firmware update. This function allows
the user to install firmware that has been placed on the SD-
card
Setup of maintenance functions
Suppresses individual alarms
Lists parameter changes, FW updates, and alarm history
logs
Simulation of process values, alarms, and inputs/outputs
(channels 2 to 4)
Possibility to upgrade access level from User to Expert and
to change PIN code for "expert" level
Resets device to default settings or restarts device
SIMATIC PDM
183