Engine Break-In Period; Engine Lubrication Specifications - Polaris RANGER 500 2018 Service Manual

ENGINE / COOLING SYSTEM

ENGINE BREAK-IN PERIOD

The break-in period consists of the first 25 hours of
operation, or the time it takes to use 15 gallons (57 liters)
of fuel. Careful treatment of a new engine and drive
components will result in more efficient performance and
longer life for these components.
CAUTION
Use only Polaris PS-4 Synthetic Engine Oil.
Never substitute or mix oil brands.
Serious engine damage and voiding of warranty can
Do not operate at full throttle or high speeds for
extended periods during the first three hours of use.
Excessive heat can build up and cause damage to
close fitted engine parts.
1. Fill fuel tank with unleaded fuel which has a minimum
pump octane number of 87 = (R+ M)/2.
2. Refer to Chapter 2. Check oil level indicated on the
dipstick. Add oil if necessary.
3. Drive slowly at first to gradually bring engine up to
operating temperature.
4. Vary throttle positions. Do not operate at sustained
idle or sustained high speed.
5. Perform regular checks on fluid levels, controls and
all important bolt torques.
6. Change oil and oil filter after break-in period at 25
hours.
3.18
result.

ENGINE LUBRICATION SPECIFICATIONS

FLUID CAPACITY
Oil Capacity
Approx. 2 Quarts (1.9 L)
Oil Filter Wrench
PU-50105 or 2.5" (64 mm)
Oil Type
Polaris PS-4 Synthetic Engine Oil
Oil Pressure
Minimum Specification
(using Polaris PS-4 at operating temperature)
10 PSI @ 1200 RPM (Minimum)
40 PSI @ 7000 RPM(Minimum)
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
© Copyright Polaris Industries Inc.