Shipping Damage; Exterior Loading; Lifting And Moving The Case; Remove Shipping Riders And Brackets - Hussmann XR75CX Installation & Operation Manual

Table of Contents

Advertisement

I
1-2
nstallatIon

SHIPPING DAMAGE

All equipment should be thoroughly
examined for shipping damage before and
during unloading. This equipment has been
carefully inspected at our factory. Any
claim for loss or damage must be made to
the carrier. The carrier will provide any
necessary inspection reports and/or claim
forms.
Apparent Loss or Damage
If there is an obvious loss or damage, it
must be noted on the freight bill or express
receipt and signed by the carrier's agent;
otherwise, carrier may refuse claim. The
carrier will supply necessary forms.
Concealed Loss or Damage
When loss or damage is not apparent
until after equipment is uncrated, a claim
for concealed damage is made. Upon
discovering damage, make request in writing
to carrier for inspection within 15 days and
retain all packing. The carrier will supply
inspection report and required claim forms.

EXTERIOR LOADING

Do NOT walk on top of case(s) or damage
to the case(s) and serious personal injury
could occur. They are not structurally
designed to support excessive external
loading such as the weight of a person.
Do not store items or flammable materials
atop the unit. Do not walk on case.
P/N 3143042_B
U.S. & Canada 1-800-922-1919 • Mexico 800-890-2900 • WWW.HUSSMANN.COM

LIFTING AND MOVING THE CASE

The case can be moved with pallet jacks
and/or j-bars. Use the sheet metal lifting
brackets as shown below. The brackets are
at each end of the case. Position the jacks or
j-bars underneath these lifting brackets for
transit to the final location.
Be careful not to damage the ends of the
case when positioning and moving. The
edge guard can be removed if needed.
Lifting Bracket at each end of case
REMOVE SHIPPING RIDERS AND
BRACKETS
There are two 2" x 8" shipping riders that lift
the case about a ¼" off of the floor. They
are installed in the front and rear bottom
interior. The riders are bolted to the case
with sheet metal brackets. Remove the
riders and brackets.
Front Shipping Rider
(rear brace not shown)
Rider Brackets

Advertisement

Table of Contents
loading

This manual is also suitable for:

EgpEgpf merchandisers

Table of Contents