Model Description; Unloading; Unloading From Trailer; Exterior Loading - Hussmann GSVM Installation & Operation Manual

P/N 0545716_G

MODEL DESCRIPTION

The GSVM open vertical merchandiser offers
versatility in the display of medium temperature
(32º F to 41º F) products such as dairy products,
prepared salads, pizza and fresh entrees that
are pre-chilled in a cooler. Carefully read and
follow the instructions prior operating the mer-
chandiser.

UNLOADING

Unloading from Trailer:

Lever Bar (also known as a Mule, Johnson
Bar, J-bar, Lever Dolly, or Pry Lever)
Move the merchandiser as close as possible to
its permanent location and remove all packaging.
Check for damage before discarding packaging.
Remove all separately packed accessories such
as kits and shelves. Improper handling may
cause damage to the merchandiser when unloading
to avoid damage:
Do not walk or put heavy objects on case.
1. Do not drag the merchandiser out of the
trailer. Use a Johnson bar (mule).
2. Use a forklift or dolly to remove the
merchandiser from the trailer.

EXTERIOR LOADING

Do NOT walk on top of merchandisers or
damage to the merchandisers and serious
personal injury could occur.
merchandisers are not structurally
designed to support external loading
such as the weight of a person. Do not place
heavy objects on the merchandiser.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.

SHIPPING SKID

Each merchandiser is shipped on a skid to
protect the merchandiser's base, and to make
positioning the case easier.
Do not remove the shipping skid until the
merchandiser is near its final location. The
skid provides protection for both the merchan-
diser and the floor.
Remove the skid by raising one end of the
merchandiser approximately 6 inches. Block the
merchandiser securely, and remove the two skid
bolts from the raised end. Replace the bolts
with (provided) leg levelers. Repeat this proce-
dure at opposing end. Once the leg levelers are
secured in place, the merchandiser may be slid
off the skid and placed in its final location.
DO NOT TILT MERCHANDISER ON ITS
SIDE OR END WHEN REMOVING SKID.
Once the skid is removed, the merchandiser
must be lifted —NOT PUSHED— to reposition.
Check floor where merchandisers are to be set
to see if it is a level area. Determine the highest
part of the floor.
Do NOT remove shipping crate until the
merchandiser is positioned
for installation.
Do NOT stand or walk on top of
merchandiser. Do not store items or
flammable materials atop the unit.
GSVM Open Vertical Merchandisers
1-3