Table of Contents
Advertisement
Installation
This section describes the installation and setup of the SW4 12G HD-SDI switchers. Topics
include:
•
•
•
Installation Overview
To install and set up the SW4 12G HD-SDI switcher:
1.
2.
3.
4.
5.
6.
Installation Overview
Rear Panel Features
Wiring for RS-232 Control
Turn off all equipment and disconnect it from the power source.
(Optional) Mount the switcher on a rack shelf or furniture (see
SW4 12G HD-SDI Switcher
Connect video inputs to the BNC input connectors 1 through 4 (see
the next page).
NOTE: Each input is equalized regardless of the rate.
Connect one or two video output devices to the BNC output connectors (
NOTE: Mirrored outputs 1 and 2 output identical signals.
If the switcher will be connected to a computer or host controller for remote
configuration and control, do either of the following:
•
Wire the provided 3-pole captive screw connector to an RS-232 cable. Connect
the RS-232 cable to the RS-232 port on the rear panel of the switcher and to the
host RS-232 port (see the illustration at right). Protocol for the RS-232 port is 9600
baud, 8 data bits, 1 stop bit, no parity.
•
Connect a USB A to mini B cable from the computer to the front panel USB Config
port (see
figure
4,
, on page 6).
B
Power on the input and output devices, then connect power to the switcher by
connecting the provided IEC power cord to the switcher power connector (see
) and to an AC outlet.
A
on page 31).
SW4 12G HD-SDI • Installation
Mounting the
figure
2,
, on
B
).
C
figure
2,
3
Advertisement
Table of Contents
