Locking The Front Panel (Executive Mode) - Extron electronics SW4 12G HD-SDI User Manual

Locking the Front Panel (Executive Mode)

To prevent front panel input buttons being pressed accidentally or by unauthorized users,
you can place the switcher in front panel lock mode.
To toggle lock mode on and off, use any of the following methods:
Press and hold the Input 1 and Input 2 buttons simultaneously, until all front panel LEDs
•
blink three times (approximately 5 seconds).
• PCS — See
SIS commands — See the
•
page 12.
If an input button is pressed while the switcher is in front panel lock mode, all front panel
LEDs blink once, then the switcher reverts to the currently selected input.
NOTE: RS-232 and USB communication remain enabled while the switcher is in lock
mode.
Enabling and disabling front panel lockout
Front Panel Lockout (Executive Mode)
on page 26.
commands on
SW4 12G HD-SDI • Operation 8