Nautilus E618 Service Manual page 78

3. Gently lift and remove the Console/Static Handlebar Assembly from the
Console Mast and disconnect the four cables (the Input/Output, Lift Motor,
Resistance Control, and Incline Control Cables) that come from the back
of the Console.
Note: Do not let the Cables fall down inside the Console Mast. If neces-
sary, use a rubber band or wire tie to secure them. This step may require
two people.
4. Using a #2 Phillips screwdriver, remove the 4 screws from each set
(right and left) of the Handlebar Shrouds. After removing the hardware,
pinch the Handlebar Shrouds to unsnap them from each other. Place them
safely aside.
5. Using a 6mm hex wrench and a 13mm wrench, remove the indicated
hardware from the Lower Handlebar Arms and Pedals.
Be aware that the Handlebar Arm will be loose and may pivot
when the hardware is removed.
Note: To assist with reassembly, observe how the Pivot Sleeve engages
flush with the Lower Handlebar Arm.
78