Nautilus E618 Service Manual page 117

17. Using a #2 Phillips screwdriver, remove the 3 indicated screws (with
arrows) that secure the Right Shroud. Remove the bottom screws first,
and then the top screw. Slowly remove the Right Shroud.
18. Measure and mark the position of the Servo Motor Bracket on the
Main Frame.
19. Insert 2.5" x 10" cardboard between the Brake Magnet and the Fly-
wheel, and tape the cardboard to the Brake Magnet.
Note: Be sure the cardboard covers all of the Brake Magnet.
20. Observe the cable routing to the wiring harness on your machine.
Disconnect the Speed Sensor Cable and Servo Motor Cable from the
wiring harness.
21. Tie the length of string to the end of the Lower Input/Output (I/O)
Cable at the top of the Mast mount. Remove the zipties that attach the
Lower Input/Output (I/O) Cable to the Frame. Pull the cable and string
down through the hole on the side of the Frame so that the string extends
through the Frame.
NOTICE: Hold the Lower Lift Motor Wire so that you do not pull it
out of the Mast. Do not crimp the cables.
22. Untie the string from the Lower Input/Output (I/O) Cable.
Motorized Lift
Cover
Servo Motor Bracket
Lower Lift Motor Cable
MCB Cover
117
Brake Magnet
Flywheel
Tension Spring
Input/Output (I/O)
Speed Sensor Cable
Zip Ties
Servo Motor
Cable
Servo Motor
Power Inlet Cable
Cable