Nautilus E618 Service Manual page 110

To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from
!
the wall outlet and wait 5 minutes before cleaning, maintaining or repairing this machine. Place the power cord in
a secure location.
1. Be sure the Incline Assembly on the Rail Assembly is fully lowered.
Do not adjust the incline angle when on the machine.
Be sure the area below the machine is clear before lowering.
Push the Incline Level Decrease () button to change the incline angle of
the rail assembly, or push the 0% Incline Level Quick Button.
Disconnect all power and allow to sit for 5 minutes.
2. Carefully lift the Leg and Pedal together to move the Roller off the Rail
and set it on the floor to the outside of the Rail Assembly. If you have
access to the hardware that attaches the Incline Adjuster to the Rail
Assembly, continue to Step 10.
If additional space is required for removal and installation, continue to
Step 3.
3. Using a #2 Phillips screwdriver, remove the 4 screws from each set
(right and left) of the Handlebar Shrouds. After removing the hardware,
pinch the Handlebar Shrouds to unsnap them from each other. Place them
safely aside.
110
Incline Adjuster
Rail Assembly