Nautilus E618 Service Manual page 135

5. Using a 6mm hex wrench and a 13mm wrench, remove the indicated
hardware from the Lower Handlebar Arms and Pedal.
Note: To assist with reassembly, observe how the Pivot Sleeve engages
flush with the Lower Handlebar Arm.
6. Using a 6mm hex wrench and a 13mm wrench, remove the hardware
from the Lower Handlebar Arm and the Arm Pivot Rod. The hardware on
both ends of the Arm Pivot Rod will need to be held to remove it.
7. Remove the old Lower Handlebar Arm and replace with the new one.
8. Installation is the reverse procedure.
Make sure the Upper Handlebar Arms are secure before you
exercise.
9. Discard the old parts.
10. Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
135