Nautilus E618 Service Manual page 10

Condition/Problem
Fan will not turn on or will
not turn off
Fan will not turn on, but
Console operates
Unit rocks/does not sit
level
Foot pedals loose/unit
difficult to operate
Drive train click/tick
noise once per full crank
revolution
Knocking sound during
machine operation
Squeaking noise
that appears a few
minutes into a workout
and normally will get
progressively worse as
the workout continues
Workout results will not
sync with Bluetooth en-
®
abled device
Things to Check
Check data cable integrity
Check data cable
connections/orientation
Reset machine
Check for blockage of fan
Check leveler adjustment
Check surface under unit
Hardware
Check crank/pulley
assembly
Check foot assemblies,
leg assemblies, handlebar
assemblies
Check for loose hardware
Check hardware at
junction between Lower
Handlebar Arm and Pedal
Bolt that connects the
swing arms to the axle
running through the
console mast
Roller squeaking on rail
Current console mode
Total time of workout
Fitness machine
Bluetooth enabled device Consult your device to be sure that the Bluetooth
®
Fitness App
All wires in cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Unplug unit from electrical outlet for 5 minutes. Remove mate-
rial from fan. If necessary, detach the Console to help with
removal. Replace the Console if unable to remove blockage.
Adjust levelers until machine is level.
Adjustment may not be able to compensate for extremely un-
even surfaces. Move machine to level area.
Tightly secure all hardware on the Pedal Arms and Handlebar
Arms.
Disconnect left and right foot assemblies and rotate crank. If
sound persists, replace crank/pulley assembly. If sound does
not come from rotating crank, check foot assemblies and up-
per/lower handlebars.
Manually move foot, leg, and handlebar assemblies to isolate
sound. Replace part making sound.
Tightly secure all hardware on the Stabilizers and the base of
the Console Mast.
Make sure that the alignment tab on the Pivot Sleeve goes into
the slot in the hole. Be sure the Pivot Sleeve extends through
the opposite hole in the joint cover.
Loosen pivot rod bolt slightly until noise goes away. White
lithium grease can also be applied for a temporary fix. Contact
Customer Care for assistance.
Apply silicone lubricant to a dry cloth and wipe the rails to
eliminate roller noise.
Machine must be in Idle Mode to sync. Push the PAUSE/END
button until the Power-Up Mode screen is displayed.
A workout must be longer than 1 minute to be saved and
posted by the Console.
Unplug unit from electrical outlet for 5 minutes. Reconnect to
outlet.
feature has been enabled on it.
Review Specifications of Fitness App and confirm your device
is compatible.
Contact appsupport@nautilus.com (if inside US/Canada)
or your local distributor (if outside US/Canada) for further
assistance.
10
Solution
wireless
®