Nautilus E618 Service Manual page 71

To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the
!
wall outlet and wait 5 minutes before cleaning, maintaining or repairing this machine. Place the power cord in a secure
location.
1. Using a #2 Phillips screwdriver, remove the 4 screws from each set
(right and left) of the Handlebar Shrouds. After removing the hardware,
pinch the Handlebar Shrouds to unsnap them from each other. Place
them safely aside.
2. Using a 6mm hex wrench and a 13mm wrench, remove the indicated
bolts from the Lower Handlebar Arms and Pedals. Set the hardware
safely aside for reassembly.
Be aware that the Handlebar Arms will be loose and may
pivot when the hardware is removed. This step may require
two people.
3. Disconnect the indicated Cable (with arrow) from the Upper Handlebar
that goes into the Console Mast.
4. Using a 6mm hex wrench and a 13mm wrench, remove the indicated
hardware (by oval) from the Arm Pivot Rod. Remove the hardware and
the Upper and Lower Handlebar Arms. Set them safely aside for reas-
sembly.
71
Handlebar Shrouds