National Instruments VXI-MXI-Express Series User Manual page 65

© National Instruments
T RIG GE R C ONFIGUR AT IO N
0 1 2 3
SOFTWARE
Trigger set to:
Into the frame
Trigger set to:
Out of the frame
Figure D-1. Trigger Configuration Sticker
(Located on the Side of the NI VXI-8360LT)
Software controls whether the trigger is routed In to the Frame or Out of
the Frame.
Triggers are mapped into and out of your NI VXI-8360LT though software
using the following steps.
1. Open MAX.
2. Find your device under Devices and Interfaces.
3. Right click on your device and select Properties.
4. Click on the Signal Mappings Tab.
5. For each TTL Trigger select Into the Frame, Out of the Frame,
or None.
6. Click OK and re-run the Resman for the changes to take effect.
Appendix D Using the Trigger Ports on the NI VXI-8360LT
Switches shown in
Receiver / Wired-Or
position.
4 5 6 7 Trigger Number
HARDWARE
Receiver w/ Bias Device
Receiver
Driven
Wired-Or
D-3 VXI-MXI-Express Series User Manual