National Instruments VXI-MXI-Express Series User Manual page 55

Appendix B Advanced Hardware Configuration Settings
VXIbus CLK10 Routing
VXI-MXI-Express Series User Manual
When the NI VXI-8360T/LT controller is installed in Slot 0 of your
mainframe, it supplies the VXIbus CLK10 signal. Three different sources
for CLK10 are available with the NI VXI-8360T/LT controller:
• The internal 10 MHz ±100 ppm CLK10 oscillator. This is the default
CLK10 source.
• The front panel EXT CLK SMB connector. When configured as an
input the front panel SMB allows an external source to be used as the
source for the VXIbus CLK10 signal.
•
(NI VXI-8360T Only)
can be routed into the NI VXI-8360T from another NI VXI-8360T
through the TRIG/CLK PORT A(B) on the front panel. Onboard
jumpers are used to set this configuration.
The front panel TRIG/CLK PORT A(B). CLK10
B-4 ni.com