National Instruments VXI-MXI-Express Series User Manual page 52

Advanced Hardware
Configuration Settings
Note To gain access to the jumpers, remove the side panel cover that is fastened with
screws.
© National Instruments
This appendix describes the alternate hardware configuration settings for
the NI VXI-8360T/LT controller. The board is set at the factory for the most
commonly used configuration. This information is intended for more
advanced users. Do not attempt to reconfigure any jumpers unless you are
familiar with its purpose.
The following hardware configuration settings are user configurable.
• Slot 0 detection
• VXIbus CLK10 routing
• SMB Trigger I/O
• Backplane trigger I/O
For the jumper locations and default settings, see Figure B-1,
Jumper Settings.
B-1
Default
VXI-MXI-Express Series User Manual