LS10143-001SK-E
4.
Attach the annunciator/ door assembly to backbox as shown in Figure 4-14 using the supplied screws.
Figure 4-27 Attaching Annunciator/Door Assembly to Backbox
4.7.1.2 Surface Mounting
The Model RA-100TR trim ring kit is available for use when surface mounting.
1.
Remove the desired knock out. See Figure 4-26.
2.
To properly mount the backbox, insert a single screw into the key shaped mounting hole. Do not tighten all
the way. See Figure 4-28.
Place a level on top of the backbox, with the backbox level insert the rest of the mounting screws.
3.
Run wires to the control panel.
Key Shaped
Mounting Hole
Backbox
mounting holes
Figure 4-28 Backbox Surface Mount Holes
4-20
Control Panel Installation