These instructions must be framed and displayed next to the IFP-2100ECS panel in
accordance with NFPA 72 fire code for Local Protected Fire Alarm Systems.
Operation
Silence Alarms
Press
SILENCE
and Troubles
1.
2.
Reset Alarms
3.
Note: To reset ECS at an LOC, the user must gain ECS Control (See Figure 1).
The highest priority event will display first. Press the Down arrow to view location and type of alarm or trouble.
View all active
alarms, troubles,
and supervisory
signals
1. Press
View a Point's
2. Press 2 to select Point Functions.
Status
3. Then press 2 to select Point Status.
4. Select the module the device is located on by using the Up or Down button. Then press ENTER.
5. Enter the point number.
Hold the DRILL button and then enter a code if prompted. OR
Conduct a Fire
1.
Drill
2.
3.
4.
NOT APPROVED BY VERMONT FOR FIRE DRILLS.
Model IFP-2100ECS
Basic Operating Instructions
FS = Fire System
ECS = Emergency Communication System
then enter a code if prompted. Silence LED will light.
Press RESET.
Press 1 to Reset Fire System.
Press 2 to Reset Emergency Communication. System.
ENTER
to access Main Menu.
Enter the installer code. The panel will automatically go to the main menu.
Press 1 to select System Tests.
Enter code if prompted, then press 1 to select Fire Drill.
Press
ENTER
to start the fire drill, and Press ENTER to end the fire drill.
Task to Perform