Operations Mode Behavior - Honeywell IFP-2100 Installation And Operation Manual

LS10143-001SK-E
Operation
Occurs When
Mode
Normal No alarm or
trouble condition
exists and
menus are not in
use.
A smoke
detector goes
into alarm or a
pull station is
activated.
Alarm
If more than 3
categories are
active at a single
time and ECS is
enabled.
Table 10-2: Operations Mode Behavior
System Behavior
SYSTEM POWER LED is on.
The All Systems Normal display indicates that
the system is in normal mode.
The current date and time display on the last
line of the LCD.
The system seizes control and will the central
station.
The on-board annunciator will sound loud,
steady beeps to distinguish Alarm signals. For
Fire Alarm, the sequence is a loud steady
beep.(Any notification devices attached to the
system will also sound). For ECS Alarm, the
sequence is four seconds on, one second off.
GENERAL ALARM LED is on.
The LCD displays a screen similar to this one.
10-12
System Operation
In This Mode You Can
Enter the appropriate code to activate the User or
Installer Menu.
Press the down arrow to view the alarm. A screen
similar to this one displays.
Press SILENCE to silence the annunciator (and
any notification devices attached to the system).
When the alarm condition clears, press RESET to
restore the panel to normal.