Edit Modules; Editing Module Id; Naming Modules - Honeywell IFP-2100 Installation And Operation Manual

LS10143-001SK-E
9.2 Modules
This section lists the options available under the module option in the Panel Programming. The following
modules are available for the control panel: 5824 serial/parallel/IO printer interface module, RA-2000, RA-1000
& RA-100 LCD remote annunciators, 5815XL SLC Loop expander for SD devices, 6815 SLC Loop Expander
for IDP or SK, RPS-1000 power supply, 5496 NAC expander, 5880 LED I/O module, 5865 LED annunciator
Module, ECS-50W, ECS-125W, or ECS-INT50W watt voice amplifiers, ECS-AMP audio/voice amplifier, ECS-
DUAL50W dual channel amplifier, ECS-VCM voice control module, ECS-NVCM network voice control
module, ECS-RVM remote voice module, and SK-NIC network Interface card.
9.2.1

Edit Modules

The features that can be edited when this option is selected are module ID, module name, or features that are
specific to the module to be edited.
To edit an existing module:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
Note: If you are working on a networked system you will need to select which panel you want to program
3. Press 1 to enter module menu.
4. Press 1 to edit a module.
5. Use the up or down arrow key to select the module you wish to edit.Then press ENTER.

9.2.1.1 Editing Module ID

6. Press the up or down arrow key to modify the module ID.
Note: Internal devices, SK-NIC and ECS-NVCM are not able to have their module ID edited.

9.2.1.2 Naming Modules

You can assign an English name to a system hardware module to make it easier to recognize on a display.
7. If you wish to edit the module's name, press ENTER on the module's name. Then, press the number keys
corresponding to the character for the module's, name (or press right arrow key to bypass editing the name).
Note: See Appendix B for editing names.
Default name for the Internal
SLC module
(no customization)
Use up or down arrow key to select
Mode. Press the number until
the character wanted is
shown. Press left/rt arrow
Figure 9-1 Edit module Name Programming Screen Example
9-2
Programming