Wiring Sd Detectors; Addressing Sd Devices; Heat Or Smoke Detector Connection To The Facp; Idp Or Sk Slc Device Addressing Using Rotary Dials - Honeywell IFP-2100 Installation And Operation Manual

LS10143-001SK-E
in Figure 7-4.
All dials labeled for ONES
or TENS position.
Figure 7-4 IDP or SK SLC Device Addressing Using Rotary Dials
7.8

Wiring SD Detectors

The information in this section applies to SD Detectors.See Table 7-3 for P/N's.
To Wire SD Detectors
1. Wire device bases as shown in Figure 7-5.
2. Set the address for each device as described in Section 7.9.
Figure 7-5 Heat or Smoke Detector Connection to the FACP
7.9

Addressing SD Devices

This section explains how to address SD detectors and modules. See Table 7-3 for a list of SD devices.
An access code with the option to set SLC Device Address enabled is required to perform this task.
To address a SD detectors:
IDP, SK, SD and SWIFT™ SLC Device Installation
Example 2: Device Set to 105.
7-8