System Requirements - Zte ZXV10 H100 User Manual

ZXV10 H100 Home Gateway User Manual (Draft)
table below:
LAN 1 2 3 4
On the rear panel of the ZXV10 H100, are two RJ–45 LAN network interfaces, three
RJ–11 interfaces, the reset button and the power supply slot. The details are shown in
the table below:
Reset button
WLAN button
Bluetooth button

1.5 System Requirements

Hardware Requirements
•
•
•
Software Requirements
•
•
•
•
Indicators
The green indicator is solid
on
Off
Flashing
Buttons
You need an ADSL modem to access the services provided by the Internet
Service Provider (ISP);
One PC installed with a 10 Mbps,100 Mbps or 10/100 Mbps Ethernet card;
If necessary, a Ethernet hub and Ethernet cables can be added to construct a
small and medium Intranet;
Each computer accessed into the network should be installed with the network
card driver and the TCP/IP protocol and have correct network settings;
The H100 has a fixed IP address, or a dynamic IP address allocated from the
DHCP server, or an IP address allocated in the PPPOE dial-up. You also need to
set the gateway server address and the DNS server address provided by your
ISP;
The Windows 98/Me/2000/NT/Xp or Linux operating system should run
normally;
One PC of the LAN should be installed with the WEB explorer (Microsoft
Status
The physical link connection is normal
The device is powered off/the network cable is
unconnected
Flashing according to the network traffic
Default functions of the reset button
Switch on/off the Wi-Fi function
Switch on/off the Bluetooth function
1-4
Description
Description