Figure 34: Ntrip System - Novatel SMART7 Installation And Operation Manual

Chapter 6 Ethernet Configuration
The NTRIP caster is an HTTP internet service that acts as a communication medium between
NTRIP servers and NTRIP clients. The NTRIP caster is provided by third party sources. For a full
list of NTRIP casters, refer to the following link: http://www.rtcm-ntrip.org/home.
The following procedure describes how to configure a NovAtel base and a NovAtel rover through
a third party NTRIP caster. This configuration is recommended for optimal RTK performance.
1. Establish a connection to the receiver using either NovAtel Connect or another terminal pro-
gram. This connection is used to send the commands in this procedure to the receiver.
For information about establishing a connection using NovAtel Connect, refer to
the Help within NovAtel Connect.
NovAtel Connect version 2.0 or greater is required for OEM7 receivers.
Download the latest NovAtel Connect software and documentation from
www.novatel.com/novatel-connect.
2. Connect the Ethernet cable to the Ethernet ports on both OEM7 receivers. For this setup, use
a cross-over Ethernet cable.
3. Establish a static or dynamic Ethernet connection.
For information about creating the connection, refer to Static IP Address Configuration on
page 91 or Dynamic IP Address Configuration on page 94.
4. Use the following commands to enable the base receiver as an NTRIP Server:
SMART7 Installation and Operation User Manual 0C

Figure 34: NTRIP System

97