Smart7-I And Smart7-W Wi-Fi Configuration Overview; Wi-Fi Modes; Access Point (Ap); Client - Novatel SMART7 Installation And Operation Manual

SMART7-I and SMART7-W Wi-Fi Configuration Overview

SMART7-I and SMART7-W Wi-Fi Configuration Overview
Wi-Fi is a Wireless Local Area Network (WLAN) used to exchange data wirelessly over a com-
puter network.
The SMART7-I and SMART7-W models have a Wi-Fi transceiver that works as a 2.4 GHz 802.11
Access Point (AP). On startup, SMART7 automatically configures itself as an AP. The Wi-Fi AP is
configured with the settings shown in Table 14: Wi-Fi Default Configuration on the next page
and is enabled when the SMART7 is powered on. The default AP configuration can be over ridden
using the WIFIMODE command and SAVECONFIG command. Refer to the
mands and Logs Reference Manual
The SMART7 supports three modes of operation plus On and Off.
By default, the SMART7 receiver is configured to run as a 2.4 GHz 802.11 Access Point (AP) cap-
able of accepting up to four client connections.
When the SMART7 receiver starts up, the AP starts automatically with no special configuration
required. The SSID and the password/passkey are printed on a label located by the connectors
of the unit. The SSID is "SM7-<Receiver PSN>" (e.g. "SM7-ABCDEF12345678E").
Once a Wi-Fi connection is established, open a browser and navigate to the receiver's URL which
is 192.168.19.1 by default. The receiver WebUI homepage opens.
In addition, it is possible to connect to an ICOM port by establishing a terminal connection to the
receiver's IP address using TCP ports 3001 through 3007.

5.3 Wi-Fi Modes

5.3.1 Access Point (AP)

AP is the Wi-Fi default mode at start up. This mode is used by the SMART7 to wirelessly connect
to devices defined as clients or concurrent. Refer to Enable the Wi-Fi Client on page 83 for
detailed instructions.

5.3.2 Client

When in Client mode, the SMART7 can only communicate with APs. Refer to Enable the Wi-Fi Cli-
ent on page 83 for detailed instructions.

5.3.3 Concurrent

When set to Concurrent mode, the SMART7 can act as both an AP and a Client. Refer to Enable
the Wi-Fi Concurrent on page 84 for detailed instructions.
The term passkey and password are the same.
SMART7 Installation and Operation User Manual 0C
for command details.
Agriculture Com-
81