Smart7-I And Smart7-W Wi-Fi Modes; Enable The Wi-Fi Access Point; Table 14: Wi-Fi Default Configuration - Novatel SMART7 Installation And Operation Manual

SMART7-I and SMART7-W Wi-Fi Configuration Overview
Parameter
Mode
SSID
Passkey
Channel
IP address
Netmask
To view the current Wi-Fi settings, use the WIFIAPSETTINGS log. Refer to the
mands and Logs Reference Manual
Also refer to SMART7-I and SMART7-W Wi-Fi Changes on page 85 for instructions on changing
the various default settings. Refer to SMART7-I and SMART7-W ALIGN Over Wi-Fi Overview on
page 87 for instructions on configuring ALIGN corrections.

5.4 SMART7-I and SMART7-W Wi-Fi Modes

On start-up the SMART7 configures itself as an access point by default. This can be overridden
with the WIFIMODE command and SAVECONFIG command. The WIFIMODE command sup-
ports three modes of operation (in addition to Off and On):
Enable the Wi-Fi Access Point below
l
Enable the Wi-Fi Client on the next page
l
Enable the Wi-Fi Concurrent on page 84
l
The term passkey and password are the same.

5.4.1 Enable the Wi-Fi Access Point

By default, the SMART7 is an Access Point.
1. Start a command line interface (CLI) session with the receiver.
Use a Ethernet or Serial (COM) port connection.
2. Use the WIFIMODE command to enable the Wi-Fi transceiver as an AP.
WIFIMODE AP
3. Use the SAVECONFIG command to store the change in Non-Volative Memory.
This ensures the changes are kept when the receiver is restarted.
The SMART7 has the ability to override the Access Point SSID to the existing Access Point. By
default, the SSID is the enclosure PSN prefixed by 'SM7-' (e.g. SM7-NMPX17500010L). Refer to
Change the SSID on page 86 for detailed instructions.
SMART7 Installation and Operation User Manual 0C

Table 14: Wi-Fi Default Configuration

AP
Printed on the SMART7 label ("SM7-<Receiver PSN>")
Printed on the SMART7 label
11
192.168.19.1
255.255.255.0
Default
Agriculture Com-
82