Change The Ssid; Change The Wi-Fi Channel; Change The Wi-Fi Ip Address; Disable Wi-Fi - Novatel SMART7 Installation And Operation Manual

SMART7-I and SMART7-W Wi-Fi Configuration Overview

5.5.2 Change the SSID

Use the WIFIAPSSID command to change the default SSID if required.
WIFIAPSSID <ssid>
Issue the SAVECONFIG command and restart the SMART7 to change the SSID.

5.5.3 Change the Wi-Fi Channel

1. Start a CLI session with the receiver.
Use a Ethernet or Serial (COM) port connection.
2. Use the WIFIAPCHANNEL command to change the Wi-Fi channel.
WIFIAPCHANNEL 3
The channel must be a number from 1 to 14.
The Wi-Fi channel will not change until the Wi-Fi transceiver has been restarted.
3. Use the WIFIMODE command to restart the Wi-Fi transceiver.
WIFIMODE AP
4. Use the SAVECONFIG command to store the change in Non-Volative Memory.
This ensures the new channel is kept when the receiver is restarted.
5.5.4 Change the Wi-Fi IP Address
1. Start a CLI session with the receiver.
Use a Ethernet or Serial (COM) port connection.
2. Use the WIFIAPIPCONFIG command to change the Wi-Fi IP address and netmask.
WIFIAPIPCONFIG xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy
In the command above xxx.xxx.xxx.xxx represents the IP address and yyy.yyy.yyy.yyy rep-
resents the netmask. For example:
WIFIAPIPCONFIG 192.162.55.20 255.255.0.0.
The Wi-Fi IP address and netmask will not change until the Wi-Fi transceiver
has been restarted.
3. Use the WIFIMODE command to restart the Wi-Fi transceiver.
WIFIMODE AP
4. Use the SAVECONFIG command to store the change in Non-Volative Memory.
This ensures the new IP address and netmask are kept when the receiver is restarted.

5.5.5 Disable Wi-Fi

1. Start a CLI session with the receiver.
Use a Ethernet or Serial (COM) port connection.
2. Use the WIFIMODE command to disable the Wi-Fi transceiver.
SMART7 Installation and Operation User Manual 0C 86