Smart7 Data Communication Specifications; Smart7 Strobe Specifications; Table 25: Data Communications Interfaces - Novatel SMART7 Installation And Operation Manual

APPENDIX A SMART7 Technical Specifications
A.4 SMART7 Data Communication Specifications
Electrical format
1
Data rates
Signals supported
SMART7 port
Electrical Format
Data rates
SMART7 port
Physical layer
SMART7 port
Security
Encryption
Security
Encryption
A.5 SMART7 Strobe Specifications
All of the SMART7 strobe signals are available on the 14-Pin Interface connector. Pulse Per
Second (PPS) strobes provide synchronization signal.
Refer to SMART7 Interface Cable (Optional Accessory) on page 136 for pin out details.
1
Data rates higher than 115200 bit/s are not supported by standard PC hardware. Special PC hardware may be
required for higher rates, including 230400 bit/s and 460800 bit/s.
SMART7 Installation and Operation User Manual 0C

Table 25: Data Communications Interfaces

COM1, COM2, COM3
RS-232
2400, 4800, 9600 (default), 19200, 38400, 57600, 115200, 230400 bit/s
COM1_Tx, COM1_Rx, COM2_Tx, COM2_Rx, COM3_Tx, COM3_Rx
14-Pin Tyco Ampseal
ISO 11898-2
1 Mbps maximum
CAN Bus throughput is determined by slowest device on the bus
14-Pin Tyco Ampseal
10BASE-T/100BASE-TX
M12 D-code male
Wi-Fi Access Point
WPA2
AES
Wi-Fi Client Point
OPEN, WPA, WPA2
TKIP, AES CCMP
CAN Bus
ETHERNET
134