Table 18: Resolving An Error In The Receiver Status Word - Novatel SMART7 Installation And Operation Manual

Chapter 8 Troubleshooting
Bit Set
22 Reload firmware using WinLoad or the SoftLoad commands.
23-30 Reserved
31 Possible hardware failure. Contact Customer Support on page 14.

Table 18: Resolving an Error in the Receiver Status Word

Bit Set
Check the Error Word in the RXSTATUS log. See also Table 17: Resolving a Receiver
0
Error Word on the previous page
Check the temperature ranges in
1
SMART7 Environmental and Electrical Specifications on page 133
l
See
2
Power Supply Requirements for the SMART7 on page 22
l
3
4
For SMART7, contact Customer Support on page 14
5
6
Check the CPU idle time. Check for unnecessary logging. Check for simultaneous use of
7
functionality.
See Table 9: Serial Ports Supported on page 31
8
Also, check the Auxiliary 2 Status word to determine which COM port has overrun its
buffer.
9-11 Reserved
15 Check the Auxiliary 1 status word to determine which RF channels are jammed.
16-17 Reserved
When the receiver has tracked GNSS satellites long enough for a valid almanac to be
18
received, this bit will be set to 0.
19 None. This bit only indicates if the receiver has calculated a position.
None. This bit is a status bit indicating if the receiver's position has been manually fixed
20 and does not represent a problem. Refer also to the FIX command in the
Commands and Logs Reference
SMART7 Installation and Operation User Manual 0C
Action to Resolve
Action to Resolve
Manual.
Agriculture
109