Figure 33: Base/Rover Ethernet Setup-Oem7 Receiver - Novatel SMART7 Installation And Operation Manual

Chapter 6 Ethernet Configuration
Figure 33: Base/Rover Ethernet Setup—OEM7 Receiver below shows the connections when a
base and rover OEM7 receiver are connected using Ethernet.
Figure 33: Base/Rover Ethernet Setup—OEM7 Receiver
1. Connect your computer to both OEM7 receivers using null modem serial cables or USB
cables.
2. Establish a connection to the receiver using either NovAtel Connect or another terminal pro-
gram. This connection is used to send the commands in this procedure to the receivers.
For information about establishing a connection using NovAtel Connect, refer to
the Help within NovAtel Connect.
NovAtel Connect version 2.0 or greater is required for OEM7 receivers.
Download the latest NovAtel Connect software and documentation from
www.novatel.com/novatel-connect.
3. Connect the power cables to both of the OEM7 receivers and apply power to the receivers.
4. Connect the Ethernet cables to the Ethernet ports on both OEM7 receivers.
5. Establish an Ethernet connection, either static or dynamic configurations. Refer to Static IP
Address Configuration on page 91 or Dynamic IP Address Configuration on the previous page
for more information.
6. Send the following commands to each receiver either through serial or USB ports:
Base:
FIX POSITION <lat> <long> <height>
INTERFACEMODE ICOM1 NONE RTCA off
LOG ICOM1 RTCAOBS2 ONTIME 1
SMART7 Installation and Operation User Manual 0C 95